Checking The Production Process With Trend Analyses

The challenge

In series production, it is important to ensure the process security of production because every part is supposed to have the exact same quality. That is why it is necessary to continuously monitor whether and to what extent the production process is changing.

The solution

ATOS systems with high measuring speed and assured measuring data quality support the monitoring of the production process efficiently. Optical metrology helps to observe how the production deviates over time. Checking parts from series production fully and regularly opens up the following possibilities:

Such an inspection shows how the entire surface of serial parts varies. This helps to estimate how stable the production process is.
It is possible to analyze trends at every surface point of the part and for every feature, such as whole position or trimming points. In this way, critical developments can be found in time.
Any statistic analysis can be carried out for every surface point and feature.

Real-time trend analyses

of the entire part surface based on full-field measurements
Analysis of the development

of part deviations at every point of the part
Improved maintenance and repair planning

of tools as well as avoiding the production of scrap by observing the changes in trend during the production process

ZEISS oplossingen voor elke stap in het productieproces

De flexibele 3D-coördinaten meetsystemen ATOS, ARAMIS en ARGUS worden gebruikt in alle processtappen van metaal omvormen. Lees meer over hoe ZEISS systemen de afzonderlijke omvormprocessen optimaliseren om kwaliteit en procesbetrouwbaarheid te garanderen.

Meer informatie